Marzhauser Sensotech Profiler ST Betriebsanleitung Seite 134

All manuals and user guides at all-guides.com
Operation
Here you can learn how to enable the position correction after
restarting the PROFILER ST:
»
X
1 Navigate through the saved segments with
2 To modify a target value, tap on the Target Pos. input field.
3 Enter the value of the measuring point approached on the
4 Confirm your entry with
5 To modify an actual value, adopt the currently measured
6 Save the entered target and actual values for the segment
The new position correction values are now saved.
X
1 To delete all segments which are saved for an axis along
2 Delete all segments which were saved for the respective axis
3 Confirm the query Delete all position correction data of
All segments which were saved for the respective axis, along
with their associated target and actual values, are now deleted.
134
Chapter 6.5.3 Enabling the Position Correction, page 135
Modifying position correction values
measurement standard via the entry bar.
position value in the Act. Pos. input field with
Note: If you would like to enter or modify the actual value
manually, tap on the Act. Pos. input field. Enter or modify
the actual value via the entry bar. Confirm your entry
with .
with .
Deleting position correction values
with the associated target and actual values, navigate with
to segment 0.
with .
axis? with .
.
Operating Manual
and .
.