Sending Position Values To A Pc - Marzhauser Sensotech Profiler ST Betriebsanleitung

All manuals and user guides at all-guides.com
PROFILER ST

6.4 Sending Position Values to a PC

You can send position values to a connected PC in two differ-
ent ways.
X
1 Send the current position values to a connected PC via
The current position values are sent to a connected PC and
can be received by GetPos, a terminal or an individual software
solution.
X
1 Send the current position values to a connected PC via
The current position values are sent to a connected PC and
can be received by GetPos, a terminal or an individual software
solution.
For programmed operation of the PROFILER ST refer to the
instruction set of the PROFILER ST.
»
Sending position values to a PC by a trigger event
button on the PROFILER ST
•
»
Chapter 6.7.7 COM (Data / Interface), page 150
foot switch (right pedal)
•
»
Chapter 5.2 Establishing the Connection to a PC,
page 116
Sending position values to a PC by a position query
button in GetPos
•
»
Chapter 7.1 GetPos Software, page 155
Enter button on your PC keyboard while GetPos is run-
•
ning
»
Chapter 7.1.4 Key Layout on a PC, page 162
instruction
•
»
Instruction set on the installation CD
Instruction set on the installation CD
Operation
129