Marzhauser Sensotech Profiler ST Betriebsanleitung Seite 127

All manuals and user guides at all-guides.com
PROFILER ST
6.2.3 Status Display Position Correction
If position correction was enabled in the Encoder menu, the
display field
display (X, Y, Z).
You can select the function for setting the machine zero in the
Origin menu.
»
6.2.4 Status Display Reference Signal
If reference signal evaluation was enabled in the Encoder
menu, the display field
position display (X, Y, Z).
appears to the left of the respective position
Red, flashing
Green, constant Machine zero was set/approached.
Chapter 6.7.3 Origin, page 140
White
The reference signal evaluation is enabled.
Green
A reference mark was approached.
Machine zero was not yet set or
approached.
The position correction is not active.
The position correction is active.
Note: For absolute measuring systems,
the machine zero is detected directly
after switching on the PROFILER ST.
Therefore, the position correction is ac-
tive immediately after switching on the
PROFILER ST.
appears to the left of the respective
Operation
127