Marzhauser Sensotech Profiler ST Betriebsanleitung Seite 142

All manuals and user guides at all-guides.com
Operation
Zero position value
with button
Set machine zero
with button
Set machine zero
with reference
switch
Set machine zero
with reference
mark
142
enable/disable ,
manual zeroing of position values
Note: The Zero position value with
button function is used for carrying out
measurements independently of the
machine zero.
»
Chapter 6.3 Performing Measure-
ments, page 128
set the machine zero with
(function not available for absolute
measuring systems/encoder type SSI)
Function description: To set the ma-
chine zero, after enabling the function
or after each time the PROFILER ST is
switched on, move your measuring set-
up to the desired position and manually
set the machine zero one time with
and .
, and are then used again
to zero the position values. Reference
signals are ignored. The position correc-
tion does not refer to reference marks,
but to the manually set machine zero.
–
Note: function not available for
PROFILER ST
set the machine zero by approaching
the nearest reference mark (function
not available for absolute measuring
systems/encoder type SSI)
Operating Manual
and for the
, and
,