Spare Parts / Wearing Parts; Environmental Protection; Maintenance; Replacing The Batteries - Bosch ACC 101 Aufbau- Und Bedienungsanweisung

7.

Spare parts / wearing parts

– Setting device, complete
– Mirror with metal frame
– Rail
– Alignment angle for rail
– Wheel laser, complete
– Slotted cover, complete
– Coarse setting device, complete
– Universal quick-change clamp
- Spacer bolt (<)
(with nose, til 6/2001)
- Spacer bolt (<)
(with nose and 2 nuts, up 6/2001)
- Ring (<)
- Spacer tube (<)
(with nose, til 6/2001)
- Spacer tube (<)
(with nose and 2 nuts, up 6/2001)
- Cap (<)
- Locking wire
- Compression spring
- Lengthening piece
- Knurled thumbscrew
- Wing screw
- Star knob screw
- Wing screw M8 x16
– Batteries(<) x2 for wheel laser
Type: mignon 1.5 V (LR 6 / AA / AM3) commercially available
– Batteries (<) x2 for coarse setting device
Type: baby 1.5 V (LR 14 / C / AM2)
(<) = wearing part
i Do not use rechargeable batteries, their voltage values are
too low!
1 687 020 406
1 685 350 013
1 682 319 031
1 681 320 077
1 685 357 058
1 688 128 044
1 687 023 337
1 688 120 140
1 683 123 057
1 683 123 056
1 680 209 025
1 680 409 029
1 680 409 028
1 680 502 021
1 684 712 014
1 684 616 023
1 683 008 007
1 683 481 060
1 683 480 012
1 686 621 059
2 912 542 238
commercially available
8.

Environmental protection

The wheel laser and coarse setting device contain
alkaline batteries. Do not dispose of these batteries as
normal waste! Please return empty batteries to the
vendor for correct disposal.
9.

Maintenance

9.1

Replacing the batteries

Wheel laser:
Open the screw-on cover on the rear side of the wheel laser.
Remove the empty batteries and replace them with new ones.
Ensure correct polarity!
Coarse setting device:
Remove the two screws of the battery compartment cover on
the rear side of the coarse setting device. Take off the cover,
remove the empty batteries and replace them with new ones.
Ensure correct polarity! Put the cover back onto the battery
compartment and screw in place.
9.2

Replacing the mirror

Replace the mirror as described in section 5.2.
10.

Technical data

Laser performance data (wheel laser / coarse setting device)
Laser diode
Wavelength
Radiated power
Point size
Operating range
Temperature range
Voltage supply
Weight
Rail
Reflector
Laser class 2
650 nm + 10 nm
0.5 - 1 mW
Ø 3 mm
approx. 30 m
–10 °C to +40 °C
3 - 6 V
approx. 7.5 kg
approx. 14 kg
27