Using Cleanspace Halo With Half Mask - CleanSpace HALO CS3000 Bedienungsanleitung

Once you have achieved an acceptable mask fit and confirmed it with a quantitative fit test, record your information
in the table below.
Name
Mask Size
Neck Support
Date of Quantitative Fit Test
Fit Factor on Test
IF A SATISFACTORY FIT FACTOR CANNOT BE ACHIEVED WITH ANY OF THE MASKS,

10. Using CleanSpace HALO With Half Mask

Complete the following five steps each time you use your respirator.
STEP 1 - INSPECT
Before each entry into a contaminated area, the following inspections must be performed:
▪
Visually check the all parts including the Respirator, mask, harness and filter. If parts are missing or damaged
replace only with approved parts before proceeding.
▪
Check the RESPIRATOR for cracks, holes or other damage or missing parts. Do not use the device if there is
any damage or misuse. Check both bellows for splits or holes. Check that the bellows have not become
distorted so as to partially or fully close the air path to the mask. Check and fit the neck support (if required).
Check the battery is fully charged by pressing the Power button. All three (3) battery Green LEDs must light
up. See Section 14.
CLEANSPACE RESPIRATORS MUST NOT BE USED
Fitted / Not Fitted
9
(Circle one)