CleanSpace HALO CS3000 Bedienungsanleitung Seite 14

•
Fit a Neck Support
Align the neck support with the respirator, the two arms with the rounded heads should be at the top. Locate
the bottom arms of the neck support in the grooves at the bottom of the unit and slide neck support upwards
until you hear a 'click'.
•
Loosen both bellows to their widest opening
Press the adjust button on the respirator and loosen the bellows on both sides so they are fully extended.
See Figure 11.
•
Place the Respirator in Standby Mode
Press the Power button once. The Green Battery LED lights will light up on the respirator. The motor will not
come on and the air will not flow in Standby Mode.
•
Don the Respirator and switch to On Mode
Place the respirator behind your neck with the bellows and mask resting down one side,. The harness should
be hanging in front of mask (Figure 12 – 14). Fasten the AirClips on your left-hand side so both sides of the
mask are connected to the Respirator. Pull the mask up to sit comfortably on your face (Figure 15). Start to
breathe to trigger the system into On Mode for the air to flow. Pull the harness back and onto your head
(Figure 16). Adjust harness and settle the mask and power unit so both are comfortable. Adjust the bellows
and harness to achieve a comfortable fit and seal on the face. DO NOT OVER TIGHTEN THE SYSTEM
(Figure 17)
Figure 10 - Fitting neck support
Figure 11 - Adjust Button
Power button on keypad
14