CleanSpace HALO CS3000 Bedienungsanleitung Seite 15

Figure 12 - Blower behind
neck
Figure 15 – Pull mask up and
onto face
ON MODE: From Standby Mode, when the mask is placed on the face, the wearers breathing will trigger the system
to start (On Mode) and the air to flow. Breathe normally. The wearer should feel fresh air on the face and the motor
adjusting to the breathing patterns.
If the motor does not start and air does not flow, check the system was in Standby Mode (with the Battery green
LEDS on). If the system is Off, (ie not in Standby Mode and no green LEDS), remove the respirator, press the
Power button to activate Standby Mode and don again as described Figures 12 – 17 above.
•
Check the Harness
The Harness should take a little of the weight of the mask and support the respirator so that the respirator system
sits level on your head. If necessary adjust the harness. This is done by shortening or lengthening the front straps of
the harness, by moving the cleats up or down the straps. Remember to shorten or lengthen each side by the same
amount.
Figure 13 – Fasten
AirClip
Figure 16 – Pull harness back
and onto head
15
Figure 14 – Device fastened
around neck
Figure 17 - Settle harness and
adjust