Using The Cleanspace Respirator With Half Masks - CleanSpace EX Gebrauchsanleitung

English
CleanSpace Respirators

8. Using the CleanSpace respirator with Half Masks

MASK FITTING –HALF MASKS
If you are using one of the following masks, read this section to learn how to fit it:
Intrinsically Safe approved
PAF-0064 Mask Half Small – Intrinsically Safe approved
PAF-0062 Mask Half Medium - Intrinsically Safe approved
PAF-0063 Mask Half Large - Intrinsically Safe approved
Before you use CleanSpace Respirator you must determine the right mask for your face and know how to adjust the machine
to achieve a good fit.
It is vital that your mask is the right size for your face and fits properly. Mask fitting must be carried out by a specialist /
designated mask fitter. The fit must be confirmed by a quantitative fit test.
To carry out a quantitative fit test your specialist mask fitter will require PAF-0025 PortaCount Adaptor and the accompanying
S005-7174 Quantitative Fit Test Instructions. The PortaCount Adaptor is an accessory that fits between the mask and the
exhalation valve and allows the air in the mask to be sampled. It comes with detailed instructions on how to carry out a
quantitative fit test.
No PAPR can fully protect you if you are not clean shaven. CleanSpace Respirator is not suitable for users with facial hair.
MASK SELECTION GUIDELINES
No set of guidelines can ensure that you have the right size mask for your face. You must confirm the fit with a quantitative
fit test. But the table below will help your mask fitting specialist to select the mask most likely to fit you, and may therefore
save time.
Once you have achieved an acceptable mask fit and confirmed it with a quantitative fit test, record your information in the
table below.
NON – Intrinsically Safe
PAF-0033 Mask Half Small
PAF-1010 Mask Half Medium
PAF-0027 Mask Half Large
8
USER INSTRUCTIONS