Cleaning - CleanSpace HALO CS3000 Bedienungsanleitung

GENERAL BATTERY INFORMATION
CleanSpace respirators have an internal lithium ion (Li-ion) polymer battery. Lithium ion (Li-ion) batteries have the
highest energy density of all battery types and are widely used in portable electronic devices. The commonly
available Li-ion polymer batteries are packaged in a soft polymer film. The soft packaging allows the cells to expand
under extreme heat, making the battery safer in fault conditions. CleanSpace respirators use quality Li-ion polymer
batteries and are designed to be viable over a minimum of 500 complete charge and discharge cycles while still
maintaining at least 70% of their specified full capacity.
RESPIRATOR STORAGE
To maintain the performance integrity of the internal battery, the respirator must be stored under the following
conditions:
Long term storage (> 30 days)
Short term storage (< 30 days)
NOTE: Precautions for use:
•
Avoid mechanical shocks or impacts from any sharp or hard objects.
•
Do not charge or use the respirator if there are any signs of severe mechanical damage
•
The respirator will stop functioning if the internal temperature rises above 60°C or falls below -10°C
•
Do not dispose of the respirator in a fire.
•
Do not use the respirator in heavy rain, or submerged in water or liquids
•
Do not disassemble the Respirator case. Disassembly will void the Manufacturer's Warranty. There are no
user serviceable parts inside the Respirator.
FLUSH WITH WATER IMMEDIATELY AND SEEK URGENT MEDICAL ATTENTION

16. Cleaning

We recommended that you clean your respirator after every use. The Respirator, mask, neck support and head
harness should be cleaned separately. To start, disassemble the mask, neck support and harness from the
Respirator before cleaning. Note: The methods to clean the equipment (outlined below) are not a disinfection
or sterilisation protocol. If disinfection or sterilisation is required, contact CleanSpace Customer Service
sales@cleanspacetechnology.com or visit our website:www.cleanspacehealth.com and download the
recommended protocols for disinfection and sterilization.
CLEANING THE MASK, HEAD HARNESS AND NECK SUPPORT
Before washing the mask, remove the valve cover over exhalation valve leaf by locating the small inlet located under
the lower, inside edge of the valve cover. Use your finger nail to unclip and push up the valve cover. Removing the
valve cover allows you to see the valve and check there is no dust or contaminants on the valve. See Figure 25.
Figure 25 - Removing the Mask Exhalation Valve cover
IN THE EXTREMELY RARE CIRCUMSTANCE THAT THE BATTERY
IS DAMAGED AND ELECTROLYTE COMES IN CONTACT WITH EYES,
30% - 50% RH, 18°C to 28°C
30% - 50% RH, -10°C to 35°C
26