Installation Instructions; Ambient Conditions And Conditions At The Place Of Installation; Transport And Unpacking The Equipment - Sartorius Stedim Biotech Sartocheck 4 plus Betriebsanleitung

5.3 Installation Instructions

5.3.1 Ambient Conditions
and Conditions at the Place
of Installation
5.3.2 Transporting and
Unpacking the Equipment
16 Installation
Downloaded from www.Manualslib.com
If the delivery has other defects:
– Immediately contact Sartorius Stedim Biotech GmbH or the Customer Service
Department in your country!
Packaging for Return Shipment
Use the original packaging and original packaging material as far as possible.
If the original packaging and original packaging material are
no longer available:
– Commission a packaging company with specialized technicians.
– Pack the unit in a shipping container in such a way that mechanical
damage is prevented.
If you have any questions about packaging and transport securing devices,
please contact Sartorius Stedim Biotech GmbH.
Check the equipment supplied against the delivery note. Please report incomplete
deliveries immediately to the shipping carrier or the supplier.
Interim Storage
The external packaging of the unit and its spare and replacement parts is designed
for a storage period of three months from delivery.
Units kept in interim storage must be stored in a closed, dry room at temperatures
from +5°C to max. +50°C.
Select a place of installation that meets the following conditions:
t
No relatively high temperature or exposure to heat or sun
t
No strong drafts
t
No aggressive chemical environments
t
No strong vibrations
t
No dust
t
No major humidity effects
The unit and its accessories are packaged according to the national custom and
protected against impacts. To avoid damaging the equipment, please comply with
the following notes and instructions:
t
Please observe the Technical Specifications in Chapter 3!
t
Please observe the weight. For transport to the unpacking site, use a floor
truck if appropriate.
t
To prevent the unit from slipping, it should always be carried or lifted by two people.
t
To open the packaging, remove the unit and place it on a workbench
or table intended for that purpose.
t
The workbench or table must be level and able to bear the appropriate load.
Allow sufficient space around the workbench or table for the operator to work.
t
Unpack the accessories and technical documents and put them in a safe place.
t
Moisture in the air can condense on the surfaces of a cold unit whenever it is
brought into a substantially warmer place. If you transfer the unit to a warmer
area, make sure to condition it for about 2 hours at room temperature, leaving it
plugged into AC power. The positive temperature differential between the inside
of the unit and the ambient environment essentially protects the unit against
humidity and moisture.
Open the packaging carefully. It is a good idea to save the packaging material
(in case the carrier wants to inspect it or the shipment has to be returned).
Dispose of packaging materials in compliance with prevailing environmental
safety regulations.
manuals search engine