Drying (F4); Pressure Gauge Function (F5) - Sartorius Stedim Biotech Sartocheck 4 plus Betriebsanleitung

7.18.4 Drying (F4)

Fig. 7-58 | Drying
Fig. 7-58a | Drying

7.18.5 Pressure Gauge Function (F5)

Fig. 7-59 | Special function: Pressure gauge function
52 Operation
Downloaded from www.Manualslib.com
After cleaning, drying follows. The drying program is structured analogously to the
cleaning program. Here too, you will be interactively guided through the individual
steps. The diagram will show you how the connections should be produced.
Description of the connections:
a: IN – Inlet pressure tubing
Connect inlet pressure tubing
b: Venting 2
Connect this outlet as defined
c: OUT – Outlet pressure tubing to the filter housing
Connect this outlet as defined
d: Venting 1
Connect this outlet as defined
e: Ext.Ref.Tank | Venting 3
Connect this outlet as defined.
You will need a coded Stäubli connector, see "Accessories."
f: This valve must not be opened before the complete drying equipment
is installed and the drying program started.
g: Pressure Vessel
The pressure vessel is not used during the drying process.
h: Collecting Flask
Connect the collecting flask as defined. This vessel is used for collecting
the used cleaning | rinsing fluid.
With the pressure gauge function, the internal and the external pressure sensor
can be used for gas measurement. For measurement with the internal pressure
sensor, the sensor (pressure gauge) is connected to the outlet. The remaining
pneumatic components are turned off. Now, Sartocheck
like a digital pressure gauge of accuracy class 0.1 and can be used to calibrate other
pressure gauges.
Do not use the pressure gauge function to monitor the pressure during
liquid filtration!
During measurement with the internal pressure sensor, a connection needs to be
made to the outlet connector to accurately read the atmospheric pressure.
manuals search engine
®
4 plus Bag tester works