Assembly; Unpacking The Cylinder - Aventics ITS Betriebsanleitung

Protection from
contamination
Danger of explosion due to exceeded limits!
Explosion protection is no longer guaranteed when specified limits are exceeded.
The limits and requirements resulting from the technical data must be observed during
installation of the cylinder (see "Technical Data" on page 75).
The installation requirements specified in these operating instructions must be observed
(see section 7.2).
During installation, also eliminate the chance of any operation of the cylinder that
deviates from the limits and is thus impermissible.
Danger of explosion in unsuitable atmospheres!
Explosion protection is no longer guaranteed if the ambient air contains aggressive
substances.
Only use the cylinder in normal industrial atmospheres.
If the ambient air contains aggressive substances, you must contact AVENTICS to
determine whether use is still possible. The address is printed on the back cover of these
instructions.
AVENTICS | ITS | R412020619–BAL–001–AD
Ensure that all compressed air connections are protected from
contamination by protective caps.
Use tape or the appropriate screw-in or plug-in protective
covers to seal off the open compressed air connections if
necessary.
7

Assembly

DANGER
7.1

Unpacking the cylinder

1. Let the cylinder acclimatize for several hours before
installation to prevent water from condensing in the housing.
2. Remove the packaging. Make sure that impurities do not enter
the system.
3. Check the cylinder for any damage caused during
transportation.
59
Assembly