Notes On Safety; About This Chapter; Intended Use - Aventics ITS Betriebsanleitung

48 AVENTICS | ITS | R412020619–BAL–001–AD

Notes on Safety

2 Notes on Safety
2.1

About this chapter

The product has been manufactured according to the accepted
rules of current technology. Even so, there is risk of injury and
damage to equipment if the following chapter and safety
instructions of this documentation are not followed.
Read these instructions completely before working with the
product.
Keep this documentation in a location where it is accessible to
all users at all times.
Always include the documentation when you pass the product
on to third parties.
2.2

Intended use

The product is a pneumatic system component that consists of a
configurable cylinder, which may optionally be equipped with a
CD12 series 5/2- or 5/3-way valve and the individual electrical
devices named in Table 1 on page 46. The product may be used as
follows:
to transport masses and transfer forces
in an explosion protection zone in accordance with the ATEX ID
(see section 5.2)
in an explosion protection zone together with individual
devices that are approved for these explosion protection zones
(see Table 1 on page 46)
The product is intended for professional use only.
In addition to this documentation, observe the information in
the operating instructions for the individual devices
(see Table 1 on page 46).
Also observe the operating conditions and limits printed on the
individual devices or stated on their rating plates.
Observe general technical rules for the selection and operation
of individual devices.