General Instructions On Equipment And Product Damage - Aventics ITS Betriebsanleitung

52 AVENTICS | ITS | R412020619–BAL–001–AD

General Instructions on Equipment and Product Damage

Unintended separation of the through piston rod!
Only applicable for cylinders with through piston rods: If both piston rod ends are twisted
clockwise in opposite directions, the piston rod halves are separated.
Always apply opposing pressure to an acting point on the piston rod on the same
cylinder side during tightening jobs.
Never perform opposing countering or rotating motions on
both piston rod ends.
Observe the adjacent warning label.
Damage due to mechanical loads!
Mechanical loads can result in damage to the cylinder.
Avoid mechanical loads when connecting the tubing.
Take into account the travel range of the piston.
Make sure that the cylinder is not damaged by falling parts or incorrect tool usage.
Especially avoid damage to the piston rod and seals.
Some piston rod attachments and mounting elements permit oscillating rotary or swivel
movements of the cylinders.
Make sure that the circumferential speed on the friction surfaces does not exceed 1 m/s.
ensuring intended use,
ensuring that operating employees receive regular instruction,
ensuring that the operating conditions are in line with the
requirements for the safe use of the product,
ensuring that cleaning intervals are determined and complied
with according to environmental stress factors at the
operating site,
ensuring the observance of ignition hazards that develop due
to the installation of system equipment,
ensuring that no unauthorized repairs are attempted if there is
a malfunction.
3 General Instructions on
Equipment and Product Damage
NOTICE