Intended Use; Description; Scope Of Delivery; Technical Design - SATA SATAjet 1500 B RP Betriebsanleitung

Operating Manual SATAjet 1500 B RP/HVLP
pational health and safety and environmental protection.
■ Heed the accident prevention regulations.

3. Intended Use

The spray gun is used to apply paints, lacquers and other sprayable me-
dia on suitable substrates.

4. Description

The compressed air required for spraying is supplied at the compressed
air connection. Pull the trigger to the first pressure point to activate the
pre-air control. Continue pulling the trigger to pull the paint needle out of
the fluid tip: the material flows without pressure out of the fluid tip and is
atomised by the compressed air flowing out of the air cap.

5. Scope of Delivery

■ Spray gun with nozzle set RP / HVLP and gravity flow cup
■ Tool kit
■ CCS clips
■ Operating Instructions
Alternative version
■ Gravity flow cups made of PVC or aluminium with different capacities
After unpacking, check:
■ Spray gun damaged
■ Complete scope of supply

6. Technical Design

6.1. Spray gun

[1-1] Anti-drip device
Round / flat fan control
[1-2]
Material flow control
[1-3]
Counter nut material flow
[1-4]
control
[1-5] Air micrometer (aif flow
control knob)
Air micrometer (air flow
[1-6]
control) locking screw
Air piston (not visible)
[1-7]
Compressed air connection
[1-8]
G ¼ „ (male thread)
[1-9] ColorCode-System (CCS)
[1-10] Spray gun handle
[1-11] Trigger
[1-12] Nozzle set consisting of air
cap, fluid tip (not visible),
paint needle (not visible)
[1-13] Spray gun connection with
QCC
[1-14] Gravity flow cup connection
with QCC
[1-15] Paint strainer (not visible)
[1-16] Gravity flow cup
[1-17] Gravity flow cup lid
EN
127