Design Of The Spray Gun; Intended Use; General Safety Instructions - SATA SATAjet 4000 B Betriebsanleitung

Operating instructions SATAjet 4000 B RP/HVLP
4.

Design of the Spray Gun [1]

[1-1] Spray gun handle
[1-2] Trigger
[1-3] Nozzle set consisting of air
cap, fluid tip (not visible),
paint needle (not visible)
[1-4] Spray gun connection with
QCC
[1-5] Gravity flow cup connection
with QCC
[1-6] Paint strainer (not visible)
[1-7] Gravity flow cup
[1-8] Gravity flow cup lid
5.

Intended Use

The paint spray gun has been designed for the application of paint, lac-
quer and other sprayable media by means of compressed air on suitable
substrates and surfaces.
6. Safety Instructions

6.1. General Safety Instructions

• Before using the spray gun, please read all safety and the operating
instructions carefully. Safety instructions and indicated safety meas-
ures are mandatory.
• Please keep all enclosed documents and make sure that the spray
gun is handed over only together with these documents.
[1-9] Anti-drip device
[1-10] Round/flat fan control
[1-11] Material flow control screw
[1-12] Material flow control counter
[1-13] Air micrometer (air flow
[1-14] Air micrometer (air flow con-
[1-15] Air piston (not visible)
[1-16] Compressed air connection
[1-17] ColorCode-System (CCS)
Warning! Attention!
nut
control knob)
trol) locking screw
EN
101