Initial Operation - SATA SATAjet 1500 B RP Betriebsanleitung

Operating Manual SATAjet 1500 B RP/HVLP
8. Operation
Danger!
Risk of injury from bursting compressed-air hose
If unsuitable compressed-air hoses are used, excessive pressure can
damage them and cause them to burst.
→ Use only solvent-resistant, anti-static and technically sound hoses for
compressed air with resistance to continuous pressure of at least 10 bar,
leakage resistance of < 1 MOhm and a min. inside diameter of 9 mm
(# 53090).
Notice!
Damage due to contaminated compressed air
Use of contaminated compressed air can lead to
malfunctions.
→ Use clean compressed air. For example, through SATA filter 100
(# 148247) outside the spray booth or SATA filter 484 (# 92320) inside
the spray booth.
Before using observe/check the following points / to ensure safe operation
of the paint spray gun:
■ All screws [2-1], [2-2], [2-3], [2-4] and [2-5] are securely attached.
Tighten screws, if necessary.
■ Paint nozzle [2-2] tightened with a tightening torque of 14 Nm [7-5].
■ Locking screw [10-1] tightened.
■ Technically clean compressed air used.

8.1. Initial Operation

■ Purge compressed-air line thoroughly prior to assembly.
■ Flush paint passage with suitable cleaning agent [2-6].
■ Screw connecting nipple [2-10] onto air connection [1-8].
■ Adjust air nozzle.
Horizontal spray [2-8]
Vertical spray [2-7]
■ Attach paint strainer [2-12] and gravity flow cup [2-13].
8.2. Normal Operation
Connecting the paint spray gun
■ Connect the compressed air hose [2-11].
US
525