Malfunctions - SATA SATAjet 1500 B RP Betriebsanleitung

Operating Manual SATAjet 1500 B RP/HVLP
EN
Attention!
Damage from wrong cleaning agents
The spray gun can be damaged by using aggressive cleaning agents to
clean it.
→ Do not use aggressive cleaning agents.
→ Use neutral cleaning agents with a pH of 6 – 8.
→ Do not use acids, caustic solutions, bases, paint strippers, unsuitable
regenerates or other aggressive cleaning agents.
Attention!
Physical damage from incorrect cleaning
The spray gun can be damaged if immersed in solvent or cleaning agent
or if cleaned in an ultrasonic cleaning machine.
→ Do not place the spray gun in solvent or cleaning agent.
→ Do not clean the spray gun in an ultrasonic cleaning machine.
→ Only use washing machines recommended by SATA.
Attention!
Damage from incorrect cleaning tool
Never use unsuitable objects to clean clogged holes. Even the tiniest
damage can influence the spray pattern.
→ Use SATA nozzle cleaning needles (# 62174) or (# 9894).
Notice!
In rare cases, it may be necessary to dismantle some parts of the spray
gun to clean them thoroughly. If dismantling should be necessary, this
should be limited just to the parts whose function brings them in contact
with the material.
■ Purge spray gun thoroughly with thinner.
■ Clean air cap with a paint brush or brush.
■ Lightly grease moving parts with high performance grease.

11. Malfunctions

The malfunctions described below may only be remedied by trained per-
sonnel.
If it is not possible to remedy a malfunction with the described corrective
actions, send the spray gun to the SATA customer service department
136