SATA SATAjet 1500 B RP Betriebsanleitung Seite 526

Operating Manual SATAjet 1500 B RP/HVLP
US
Adding material
Information!
When painting use only the quantity of material required for the work
step.
Maintain the necessary spray distance when painting. Store or dispose
of the material properly after painting.
■ Remove screw-on lid [2-14] of gravity flow cup [2-13].
■ Press anti-drip device [2-9] into screw-on lid.
■ Fill gravity flow cup (max. 20 mm below upper rim).
■ Screw screw-on lid onto gravity flow cup.
Adjusting the spray gun internal pressure
Information!
For adjustment options [3-2], [3-3] and [3-4] the air micrometer [1-5]
must be fully open (vertical position).
Information!
For the best accuracy, the spray gun internal pressure can be set using
the SATA adam 2 [3-1].
Information!
If the required gun input pressure is not present, increase the pressure
in the compressed air circuit.
Excess input pressure will cause excess removal forces.
■ Pull trigger [1-11] all the way off.
■ Adjust the gun input pressure according to one of the following adjust-
ment options [3-1], [3-2], [3-3] to [3-4]. Adhere to the maximum gun
input pressure (see 7).
■ Move the trigger to the start position.
526