Setting The Grinding Parameters; Cup Wheel; Speed; Y-Feed - struers Accutom-50 Gebrauchsanweisung

Setting the Grinding Parameters

Method Screen A

Cup Wheel

Speed

Y-Feed 


Sweeps



X-Inc.

Water

28
Accutom-50
Instruction Manual
All grinding parameters can be edited independently of each other.
See section Changing/Editing values for details on how to change
values.
Grinding Method: 1. EMPTY METHOD

Cup Wheel : M0P10

Y-Feed

 : 0.5 mm/s
X-Inc. : 0.100 mm
Rotation :
Material to be removed
F1:RECALL REL. X POS.
F2:CHANGE TO STOP POS. MODE
The Struers cup wheels are listed with their default values for speed.
Also eight undefined wheels are included for your own choice of cup
wheels. (See also configuration of cup wheels).
The speed of the cup wheel can be set between 300 and 5000 rpm
in steps of 100 rpm. The default values for all Struers cup wheels are
already saved together with the wheel definitions. Whenever a
different cup wheel is selected the recommended speed will
automatically be inserted.
The movement of the sample along the Y-axis (parallel to the cup
wheel).
Y-feed speed can be set between 0.1 mm/s and 10.0 mm/s (see
Section Grinding Parameters in Chapter 3, Consumables for
recommended setting).
The number of sweeps performed between any feed of the sample
in X-direction. Every sweep consists of both a forth and a back
movement of the sample. The number of sweeps can be set between
1 and 10.
The feed of the sample towards the cup-wheel. The X-increment can
be set in 0.005 mm steps between 0.005 and 1.000 mm.
The cooling water can be set to either on or off. For all normal
grinding operations the setting should be on.

Speed :4000 rpm
Sweeps :
Water :
OFF
:0.100 mm
1
ON