Mantis Compact ComposTumbler CT02001 Montageanleitung Seite 12

STEP 9 – INSTALLING THE DRIVE SUPPORT
WHAT YOU'LL NEED
Tools: None
Hardware: None
Parts: Drive gear and support assembly from step 8.
Assembled Drum from step 6
STEP 10 – ATTACHING THE FRAME
WHAT YOU'LL NEED
Tools: Adjustable wrench
9/16" wrench
Hardware: 10a - (2) 3/8" x 1-1/2" Fender washer
10b - (2) 3/8" Two way locknut
10c - (2) 3/8" x 4" Hex head cap screw
Parts: Item 16 - (2) Stub axle
Item 11 - (2) Frame leg
10.2
Drive support in stub
axle channel (seen from
outside drum)
On the outside of the endcap, position
the drive support into the channel on
the end of the stub axle
12
10.3
Insert one of the frame legs into the
open end of the drive support and
align the holes.
9.1
Guide the drive gear into the guide recess of
one endcap as shown.
10.1
Stub axle
(seen from inside drum)
From inside the drum, insert one of the stub axles
through the center hole in the endcap.
10.4
Fasten the frame leg, drive support, and
endcap using the hex cap screw, washer,
and locknut. Tighten the hardware with the
adjustable and 9/16" wrenches. Note: The
washer and nut should be on the inside of
the drum.
10.5 Repeat steps 10.1 through 10.4 for
the other end.