Cutting Position - Dürkopp Adler M-Type 869 Serviceanleitung

2.14.5

Cutting position

1
Caution: Danger of injury!
Turn off the main switch.
Only check and adjust the cutting position when the machine is
switched off.
Standard checking
If the machine is at position 58° on the hand wheel the threads must
be cut.
Correction
–
Undo screws on the cam 1.
–
Turn the cam accordingly.
–
Do up screws on cam 1 .
–
Check whether the threads have been cut at 58° on the hand
wheel.
Note!
Ensure that the cam is on the right.
GB
43