Position Of The Feed Dog In The Throat Plate Cut Out - Dürkopp Adler M-Type 869 Serviceanleitung

2.3.4

Position of the feed dog in the throat plate cut out

3
12
2 1
Caution: Danger of injury!
Turn off the main switch.
Only check and adjust the position of the feed dog when the machine
is switched off.
Lateral alignment
The feed dog should be at a uniform distance to the right and the left
of the throat plate.
Correction
–
Undo screw 3.
–
Undo screw 4.
–
Undo the grub screws on the stroke eccentric 6.
–
Align the feed dog support 1 laterally.
–
Tighten screw 3.
–
Tighten screw 4.
–
Place the stroke eccentric 6 right over to the right and screw in the
grub screws.
Alignment in feed direction
With a maximum stitch length the feed dog should move in the middle
of the throat plate cut out.
Correction
–
Undo screw 3.
–
Turn lever 2.
–
Tighten screw 3.
–
Check setting.
5 6 4