Mounting The Set-Value Initiator For The Direct Drive; Mg 55-3 Stand - Dürkopp Adler M-Type 869 Serviceanleitung

6.

Mounting the Set-value Initiator for the Direct Drive

6.1

MG 55-3 stand

4
3
6.1.1 Aligning the pedal
–
Screw the angle bracket 3 under the table plate 4 (refer to
chapter 3.4).
–
Screw the set-value initiator onto the angle 3.
–
Hang the rod 2 on the set-value initiator and pedal.
–
Loosen screw on the rod 2.
–
Adjust the height of the pedal rod so that the released (unused)
pedal has a decline of about 10°.
–
Tighten the screw on the rod 2.
1
2
GB
17