Connecting The Da321G Control Unit - Dürkopp Adler M-Type 869 Serviceanleitung

11.5.2

Connecting the DA321G control unit

2
34
1
–
Plug the cable from the setpoint director device (pedal) into the
B80 socket on the control unit.
–
Plug the motor sensor cable 1 into the B2 socket on the controller.
–
Plug the motor cable 2 into the B41 socket on the controller.
–
Plug the cable leading to the sewing machine into the A socket on
the controller.
–
Route all cables through the cable duct.
–
Plug the cable from the operating panel (if available) into the B776
socket.
–
Plug the cable 3 from the knee switch into the KN19 socket on the
front side.
–
Use the clips 4 to fasten down the cable 3 (only with 869-180322
and 869-280322).
3
4
KN19