Dürkopp Adler M-Type 869 Serviceanleitung Seite 58

An bauanleitung pneumatische Füsschenlüftung FLP 14-1
In struc tions for fitting pneumatic sewing foot lift FLP 14-1
2. Fitting
2.1 Mounting the cylinder
1
Aus ga be/Edi ti on:
10. 2006
Bausatz / Kit 0867 590354
Caution: danger of injury !
Turn off the main switch and pull out the mains plug before
performing the fitting operation. The fitting of the pneumatic
sewing foot lift must be carried out by qualified technicians only.
– Remove the belt guard.
– Remove the valve cap on the back.
2
– Mount the cylinder 1,
- fix the upper part to the pressure bar 2 and
- screw the lower part to the cast iron using the shoulder
screw.
– Remove the hose to the cylinder connection and replace it
against a longer hose with an adequate length (included in
the kit).
– Screw on the fastening clamp and re-lay the hose according
to the opposite pictures.
Prin ted in Fe de ral Re pub lic of Germany
Tei le-Nr./ Part-No.:
0791 867704
Blatt: 6 von 8
Sheet: from