Rules Of Use; Attachment The Tractor; Front Equipment - maschio Gaspardo PA1 Gebrauch Und Wartung

4.0 RULES OF USE

To obtain the best performance from the equipment, carefully follow what is set out below.
The Customer must ensure that Qualifi ed Operators for routine machine operation are suitably trained and prove competent in carrying
out the tasks assigned to them, taking care of their safety and that of third parties.
Depending on the quali cation level and tasks assigned, quali ed operators must be duly instructed on the machine functions so as to
operate and manage it correctly and guarantee good machine ef ciency.
• The machine must be operated by qualifi ed operators of the Customer. The operators must wear suitable personal protection
equipment (safety footwear, overalls and gloves).
• Do not wear unsuitable clothing with loose parts (necklaces, shawls, scarves, ties, etc.) which may get entangled in moving
parts.
• The Customer must apply the rules envisaged in the European Directives EEC 391/89 and 269/90 and subsequent modifi ca-
tions on the possible risks for loading and unloading operators caused by manual handling of loads.
• The following maintenance, adjustment, and work preparation
operations must be performed with the tractor off and locked
fi rmly in position with the key removed from the dashboard
and the machine positioned on the ground..

4.1 ATTACHMENT THE TRACTOR

4.1.1 FRONT EQUIPMENT

The equipment may be attached to any tractor tted out with a front
three-point universal joint.
The attachment to the tractor is a very dangerous phase. Be sure
to follow the instructions carefully throughout the operation.
The operation must be carried out on a horizontal plane, with
the equipment resting on its parking feet.
At this point, proceed as follows:
1) Hook the lifter bars onto the pins provided (1, Fig. 401) Block
with the snap split pins. Hook the chains to the lifting bars
2) Connect the third upper point (2, Fig. 401); the pin will be blocked
with the appropriate split pin; use the adjusting tierod (3, Fig. 401)
to keep the equipment perpendicular to the ground (Fig. 402).
3) Block the movement of the parallels of the tractor on the hori-
zontal plane using the stabilizers provided, so eliminating the
side swaying of the equipment. Check that the tractor hoisting
arms are positioned at the same height from the ground.
4) The hydraulic pipes must be connected correctly to the tractor
distributors following the instructions on each pipe (Fig. 403).
5) Raise the front machinery and remove the feet. In order to
guarantee the rotation of the transmission wheel, adjust the
working height of the machinery from the ground (35÷40 cm
Fig. 402). This distance must remain constant during
operation.
ATTENTION
If this height is not observed, the transmission wheel could
lose its grip and the lower part of the machinery could be
damaged by clods, boulders and stubble, etc.
cod. G19504090
DANGER
USE AND MAINTENANCE
ATTENTION
g. 401
g. 402
g. 403
ENGLISH
2
3
1
EN - 63