Before Starting Work; Distributor Test - maschio Gaspardo PA1 Gebrauch Und Wartung

ENGLISH

4.5 BEFORE STARTING WORK

Before starting the working operation grease all parts indicated by
transfer nr. 14 ('GREASE') at page 49 of this lea et.
Carry out a metering test as described in chapter 4.6 (if the Electric
Distribution Control is present, please refer to the instructions in
the relevant User and Maintenance Booklet).
4.6 DOSING TEST
4.6.1 ELECTRICAL DRIVE OF THE DOSER
Carrying out the dosing test: To rotate the dosing devices, follow
the instructions provided in the Operation and Maintenance Manual
of the Electrical Distribution Control.
4.6.2 MECHANICAL DRIVE OF THE DOSER
General information
- The correct functioning of the doser mainly depends on the
chain wheels installed in the gearbox of the transmission
wheel (see Table 5 «A-B» and page 414), depending on the
working width!
FERTILIZER
(Vacuum Precision Planters)
Working width Nr. rows x
A
(m) row distance
(cm)
2,7 6 x 45 Z12 Z20
3,0 6 x 50 Z12 Z18
3,6 6 x 60 Z16 Z20
4,2 6 x 70 Z15 Z16
4,5 6 x 75 Z16 Z16
4,8 6 x 80 Z16 Z15
5,0 5 x 100 Z20 Z18
5,4 12 x 45 Z18 Z15
6,0 8 x 75 Z20 Z15
6,4 8 x 80 Z20 Z14
9,0 12 x 75 Z24 Z12
- Before using the machine for the fi rst time, check the number
of teeth in the gearbox!
- Fill with seed before starting the distribution operatione.
ATTENTION
- Never leave seed residue inside the machine overnight,
especially in autumn!
- Many types of seed are extremely hygroscopic and form an
extremely hard crust on the doser.
- The GASPARDO doser is quick and easy to empty and clean
1) Fit the equipment with the correct metering roller, suitable with
the type of product selected.
2) Pull the inspection platform down (Fig. 415).
3) Position the required container under the metering unit and
open the spouts for product discharge (Fig. 416).
4) Calculate the gate opening value, with the help of the Table
6-7, on the basis of the type of seed (fertilizer) to be used and
the quantity to be distributed.
The distribution table it is always possible to calculate
approximate seed distribution quantities. It is, however,
always necessary to carry out a dosing test!
68 - EN
USE AND MAINTENANCE
SEED
(Seed drill for cereals)
Working width
B A
(m)
3,0 Z16 Z20
3,5 Z14 Z15
4,0 Z15 Z14
4,5 Z18 Z15
5,0 Z20 Z15
6,0 Z24 Z15
Table 5
B
B
A
g. 414
g. 415
g. 416
cod. G19504090