General Cleaning And Maintenance Work; Changing The Tines - Parkside PGK 1400 A1 Originalbetriebsanleitung

GB IE NI
Switch the tool off, unplug
it from the mains, and wait
for the tines (7) to stop mov-
ing before carrying out any
maintenance or cleaning
work on the tool.
Perform regular maintenance and
cleaning on the tool. This will en-
sure long, reliable service.
General cleaning and
maintenance work
Do not spray the tool
down with water (es-
pecially not under pres-
sure), and do not clean
it under running water.
Wear protective gloves when
carrying out maintenance
and cleaning work on the
tool to avoid injury from cuts.
Always clean the tool thoroughly after
each use. Always keep the tool clean. Do
not use cleaning fl uids or solvents.
• Remove any soil and dirt residues stuck
to the tines (7), driveshaft (
surface and vents with a brush or dry
cloth.
• Spray or rub biodegradable oil into the
tines (7).
• Clean soiled grips with a damp cloth.
• Always check the tool for obvious dam-
age such as loose, worn or damaged
parts before using it. Check that all nuts,
bolts, and screws are tight.
• Check the covers and guards for damage
and correct fi t. Change them if necessary.
12
CY
16), tool

Changing the tines

The tool is fi tted with four tine wheels that
can easily be changed in pairs.
Always change both
tine pairs at the same
time to avoid damage
to the tool from imbal-
ance.
Switch the tool off, unplug it
and wait for the tines (7) to
stop turning.
1. Pull the securing clip from the
E
bolt (15) and pull the outer sec-
tion of the chopper (7) from the
drive shaft (16).
2. Loosen the self-securing nut from
the hexagonal bolt (17) (AF 13)
and pull the inner section of the
chopper (7) away from the drive
shaft (16).
3. Clean the driveshaft (16) with
biological oil.
4. Slide the new chopper (7) onto
the drive shaft (16) in such a
way that the holes on the blade
axis line up with the holes on the
drive shaft (16).
Make sure that the tines are set
to their proper turning direc-
tion. The bevelled edge of the
chopper (7) must point in the
direction of travel of the chop-
per (7) towards the ground.
The direction of travel is
marked on the appliance
housing with an arrow.
5. Slide the hexagonal bolt (17)
through the hole situated close