Service Data - AEG BOBZDB Benutzerinformation

28 www.aeg.com
12.1 What to do if...
Problem
You cannot activate or oper-
ate the oven. The display
shows "400" and an acoustic
signal sounds.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The oven does not heat up.
The lamp does not operate.
Steam and condensation
settle on the food and in the
cavity of the oven.
There is no good cooking
performance using the Ba-
kingPlus function.
There is no good cooking
performance using the Ba-
kingPlus function.
The water in the cavity em-
bossment does not boil.
The water comes out of the
cavity embossment.

12.2 Service data

If you cannot find a solution to the
problem yourself, contact your dealer or
an Authorised Service Centre.
Possible cause
The oven is incorrectly con-
nected to an electrical sup-
ply.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The fuse is blown.
The lamp is defective.
You left the dish in the oven
for too long.
You did not activate the Ba-
kingPlus function.
You did not fill the cavity
embossment with water.
The temperature is too low.
There is too much water in
the cavity embossment.
The necessary data for the service centre
is on the rating plate. The rating plate is
on the front frame of the oven cavity. Do
not remove the rating plate from the
oven cavity.
Remedy
Check if the oven is correctly
connected to the electrical
supply (refer to the connec-
tion diagram if available).
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Make sure that the fuse is
the cause of the malfunction.
If the fuse is blown again
and again, contact a quali-
fied electrician.
Replace the lamp.
Do not leave the dishes in
the oven for longer than 15 -
20 minutes after the cooking
process ends.
Refer to "Activating the Ba-
kingPlus function".
Refer to "Activating the Ba-
kingPlus function".
Set the temperature at least
to 110 °C.
Refer to "Hints and tips"
chapter.
Deactivate the oven and
make sure that the appliance
is cold. Wipe the water with
a cloth or sponge. Add the
correct amount of water to
the cavity embossment. Re-
fer to the specific procedure.