Ottobock 17B203 Serie E-MAG Active Gebrauchsanweisung Seite 37

17
Fasten the cable dummies onto the designated recesses of the electronics and battery dummies as follows:
• From the knee joint to the electronics
• From the electronics to the battery
Fasten the dummies of the battery with receptacle and the electronics with receptacle with Plastilin® moulding
dough.
Fill the edges between the dummies and the socket with Plastilin® moulding dough in order to achieve a smooth
transition (see fig. 19). Check, ideally with a spatula, that there is one millimetre of clearance between the dummy
overhangs and the Plastilin® moulding dough. Pull one layer of 99B25 nylon stockinette over the finished orthosis
on the plaster model. In this way, the following base coat will be siphoned off evenly. The area of the receptacles is
reinforced with a layer of carbon (see fig. 20).
19
Reinforce the casing as follows:
• PVA bag
• 2 layers of perlon stockinette, reinforced with carbon
INFORMATION
The carbon maintains the tension of the casing and secures the dummies and screw connections.
• 2 additional layers of perlon stockinette
• PVA bag
Then laminate the casing with an appropriate amount of lamination resin.
17B203=* E-MAG Active
18
20
Installation instructions
Ottobock | 37