Stryker Altrix Bedienungsanleitung Seite 37

9. Discard the disposable thermal transfer devices based on your local waste management protocol.
a. Discard the disposable thermal transfer devices based on your local waste management protocol, if applicable.
D D r r a a i i n n i i n n g g w w a a t t e e r r f f r r o o m m t t h h e e r r e e s s e e r r v v o o i i r r
To drain the water from the reservoir:
1. See Removing and replacing the reservoir (page 26).
2. Dispose of the water per hospital protocol.
3. Replace the reservoir.
N N o o t t e e - - Make sure that the reservoir is dry before you store the product.
D D r r a a i i n n i i n n g g w w a a t t e e r r f f r r o o m m t t h h e e c c o o n n t t r r o o l l l l e e r r a a n n d d h h o o s s e e s s
Make sure that the controller and all components are dry before you store the product. Make sure to drain the hoses before
you store them.
1. Place the controller over a floor drain.
2. Remove the reservoir and pull up on the controller drain plug (A) to open the drain (Figure 21).
3. Connect a hose to each port.
a. If you have Colder style connector hoses, attach the service tool adapter hose (8001-999-017).
b. If you have C C l l i i k k - - T T i i t t e e hoses, make sure that the connectors and clamps are open (Figure 22).
8001-109-005 Rev C.2
A
F F i i g g u u r r e e 2 2 1 1 – – D D r r a a i i n n p p l l u u g g
33 EN