Stryker Altrix Bedienungsanleitung Seite 20

I I c c o o n n , , y y e e l l l l o o w w N N a a m m e e
Water
temperature
deviation
No water
No water flow
Check water flow
Check patient
probe (A or B)
Probe or adapter
malfunction (A or
B)
Adapter cable
disconnected (A
or B)
Patient
temperature
deviation
Patient
temperature
deviation
EN 16
A A l l a a r r m m p p r r i i o o r r i i t t y y M M e e s s s s a a g g e e
a a n n d d d d e e l l a a y y
Medium, 5 minute Water
delay temperature is
±0.8° C (1.4° F)
outside of target
temperature
Medium, 60 No water
second delay
Medium, 20 No flow detected
second delay
Medium, 10 Reduced flow
minute delay detected
Medium Abnormal change
in patient
temperature
Medium, 30 No temperature
second delay signal detected.
Medium, 30 Adapter cable not
second delay detected
Medium Patient
temperature is
more than ± 1.0°
C from target
temperature
(Only will appear
after the initial
target is reached.)
Low Patient
temperature is
more than ± 0.5°
C from target
temperature
(Only will appear
after the initial
target is reached.)
T T h h e e r r a a p p y y C C h h e e c c k k
i i n n t t e e r r r r u u p p t t e e d d
No Temporary condition
upon startup,
addition of thermal
transfer device, or
addition of water
Yes Check for leaks
Add a minimum of 2
liters of water
Yes Check for leaks and
obstructions at
connections, hoses,
and thermal transfer
devices
No Tap Confirm, if the
water port was
removed intentionally
Check for leaks and
obstructions at
connections, hoses,
and thermal transfer
devices
Yes Check probe
condition, location,
and connections
Yes Check probe or
adapter cable
condition, location,
and connections
Yes Reinsert the adapter
cable. If damaged,
replace the adapter
cable
No Check patient
condition, placement
of thermal transfer
devices, and all
connections
No Check patient
condition, placement
of thermal transfer
devices, and all
connections
8001-109-005 Rev C.2