Herunterladen Inhalt Inhalt Diese Seite drucken

Stryker Altrix Bedienungsanleitung Seite 36

Präzisions-temperaturregelsystem
Vorschau ausblenden Andere Handbücher für Altrix:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 201
O O p p e e n n i i n n g g a a n n d d s s e e c c u u r r i i n n g g i i t t e e m m s s i i n n t t h h e e s s t t o o r r a a g g e e c c o o m m p p a a r r t t m m e e n n t t
The storage compartment holds a maximum of 3 lb (1.36 kg).
To open the storage compartment door, lift up on the door (Figure 20).
The storage compartment secures the following items:
Two patient probes
Two reusable adapter cables
One reusable patient temperature output cable
Product operations manual
N N o o t t e e
• Make sure that the items are securely inside the compartment and not blocking the magnets.
• When closing the storage compartment door, do not place your fingers between the storage compartment door and the
sides of the controller.
S S t t o o p p p p i i n n g g t t h h e e r r a a p p y y o o r r p p o o w w e e r r i i n n g g o o f f f f t t h h e e p p r r o o d d u u c c t t
To stop therapy or power off the controller:
1. Press and hold the Stand-by button for two seconds.
2. Unplug the product from the wall outlet.
N N o o t t e e - - If storing the product, see Storing the controller (page 35).
D D r r a a i i n n i i n n g g t t h h e e t t h h e e r r m m a a l l t t r r a a n n s s f f e e r r d d e e v v i i c c e e s s
Read the manufacturer's operations manual for the individual thermal transfer devices (blankets and wraps) for warnings,
cautions, and safe operating instructions before use. Make sure that you drain the hoses before you put them in storage.
1. Unplug the product.
2. Remove the thermal transfer device from the patient.
3. Open the clamps on the hoses and thermal transfer devices, if applicable. See Figure 14.
4. Raise the thermal transfer devices attached to the hose above the ports on the controller. Gravity helps to drain the
water into the controller.
5. Allow most of the water to drain back into the controller. (Approximately 10 minutes).
6. See Connecting and disconnecting thermal transfer devices (page 23).
7. See Disconnecting the insulated hoses (page 23).
8. See Storing the power cord and hoses (page 34).
EN
32
F F i i g g u u r r e e 2 2 0 0 – – S S t t o o r r a a g g e e c c o o m m p p a a r r t t m m e e n n t t
8001-109-005 Rev C.2

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis