Galvamet KompaKOne Bedienungsanleitung Seite 96

EN
Once the screws have been removed, the fitting remains fixed to the system thanks
to the plastic snap pin (Fig.3.23). It is necessary to snap the pin with the aid of a
screwdriver, then proceed with removal.
Fig. 3.23
Now that the connection has been removed from the suction unit, it is necessary
to disassemble the extension from the fitting 1 and reassemble it on the fitting 2
through the 6 screws that join the two plates together as shown in Fig. 3.24
Fig. 3.24
20