Galvamet KompaKOne Bedienungsanleitung Seite 135

EN
TIMER
Use of timer facilitates cooking and can be used also as alarm.
Activation
Touch or of the desired cooking zone.
Set the cooking level with
Simultaneously touch
The timer display shows
Within the next 10 seconds, with
minutes).
The timer starts working automatically after a few seconds. The decimal point of the
cooking zone selected is blinking.
The timer can be set for each cooking zone at the same time.
To quickly set the cooking time continuously touch the sensor
Changing the pre-set cooking time
Cooking time can be changed anytime during the operation:
Touch or of the desired cooking zone.
Activate the Timer touching
blinking.
Touch or to set the new desired cooking time.
Residual cooking time
Residual cooking time can be displayed by touching the selected cooking zone and
after; or by operating more times simultaneously keys
referring to the cooking zone display will blink the decimal point.
The timer will always display the minor residual cooking time:
If the time is related to the cooking zone, the decimal point will flash in its display.
If the time is related to the alarm, there will be no decimal point blinking.
Deactivation
After the set cooking time has passed, the beep sounds at intervals, which can be off by
touching any sensor or shuts off automatically after 2 minutes.
When the set time expires, the cooking zone also goes out.
Switch off the timer before the pre-set time:
Touch or of the desired cooking zone. The decimal point will flash.
Activate the timer touching
or .
and .
.
or , set the desired cooking time, (from 01 to 99
and . The decimal point of the selected cooking zone is
and .
or .
and . The displayed time is
and
59