Galvamet KompaKOne Bedienungsanleitung Seite 137

EN
CONFIGURATION OF THE COOKING ZONES
All pots should be removed from the cooking zones and a pot suitable for induction should
be available.
You can start configuration / erase within 2 minutes from the connection to the electricity
network. The command must remain off as well as any display.
Input to configuration menu / cancellation
Keep pressed
Touch all available cooking zone buttons by proceeding counterclockwise and starting
from the right frontal one.
Sequence for 4 zones version: (5-4-3-2)
Sequence for 3 zones version: (4-4-3-2)
Sequence for 2 zones version: (4-4-3-3)
Each action is confirmed by an acustic signal:
One only "beep" → right selection
Double "beep" → wrong selection
From the last action all the displays light up showing:
→ Set up zone
→ Zone not set up
Set up cancellation procedure
After having entered the cancellation / set up menu
Keep and pressed at the same time: The display shows
cooking zones will be set up again.
All the dislays will show .
Set up procedure
After entering the setup / erasing menu and after deleting it:
Select the cooking zone to set up.
will start blinking on the corresponding display.
blinking until all the
61