Galvamet KompaKOne Bedienungsanleitung Seite 124

EN
Stable connection to the network by interposing a bipolar switch to ensure
2.
disconnection from the network, with a contact opening distance allowing complete
disconnection under the conditions of the overvoltage category III, in accordance with the
installation rules (fig.4.2).
Fig. 4.2
Earth connection (yellow-green wire) should not be interrupted.
If the power cord is damaged, it must be replaced by the manufacturer or its authorized
service center or by a qualified technician, in order to prevent any risk.
Connection procedure:
First of all connect the motor box to the induction hob:
 Connect the flat connector (male-female) to the main board, with the controls
falling down from the induction hob (Fig.4.3-A).
 Connect the main board connector (male-female) with the electronic water sensors
located inside of the hood (Fig.4.3-B).
The appliance is composed by three devices that must be separately connected to the
electricity: the serial plates stating the electricity supply needed are located under each
side of the induction hob and on the upper aspiration unit.
Connection must be carried out by means of connection cables model H05V2V2-F:
Fig. 4.3
48