Galvamet KompaKOne Bedienungsanleitung Seite 100

EN
Before fixing the induction hob, glue the foam gasket included on the the inferior part of
the glass
Caution! It is forbidden to install the hob without the foam gasket!
Remove the protective film and glue the gasket at 2mm distance from the glass edge
(A=2mm), the gasket must be attached along the entire length and should not overlap at
the corners (Fig.3.10).
Fig. 3.10
Lay in the silicone sealant flush at the hole (Fig. 3.11), place the induction hob (Fig.3.12)
Fig. 3.11
Fig. 3.12
24