Operation - Cameo EVOS S3 Bedienungsanleitung

10
PAN LOCK
Mechanical locking device used to prevent the rotation of the head in the horizontal direction during transport. Bring the head parallel to the
base (4 positions) and push the locking lever towards the rotation axis to lock. Unlock the device before startup.
11 TILT LOCK
Mechanical locking device used to prevent the rotation of the head in the vertical direction during transport (7 positions). Push the locking
lever in the direction of the rotation axis to lock. Unlock the device before startup.
LOCK
11
UNLOCK

OPERATION

MAIN DISPLAY
After the power-up process, the spotlight is ready for operation, and starts in the previously activated mode. The main display appears with
the following information: Current operating mode (in the example DMX mode with DMX address), temperature of the LED unit and the
W-DMX ™ status.
6
10
UNLOCK LOCK
PLEASE NOTE
• As soon as the spotlight is correctly connected to the
power supply, "Welcome to Cameo" will be shown on the
display during the start-up process. After this process, the
lamp is ready for operation and starts in the previously
enabled mode.
• If one of the DMX operating modes is activated and there is
no DMX signal to the DMX input, the currently programmed
DMX address is displayed and the characters on the display
will begin to flash.
• After approx. 1 minute, the current operating mode is
displayed again.
• Fast Access Feature: In order to simplify the menu guide,
the device has an intelligent menu structure that allows
direct access to previously selected menu items and sub-
menu items. 1. Press MENU and ENTER simultaneously
for direct access to the last-edited sub-menu item, where
you can make changes instantly as required (DMX starting
address and all modes). 2. Press MENU for direct access to
the last-selected and last-edited menu item. Press ENTER
repeatedly to access the sub-menu items in order to change
individual settings (DMX starting address and all modes).
• The display can be rotated through 180° by pressing UP
when the main display is visible. If the display is turned 180 °,
the DOWN button must be pressed to turn the display back.