Connections, Operating And Display Elements - Cameo EVOS S3 Bedienungsanleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS

6
5 5
7
1 POWER IN
TRUE1 compatible mains input socket. Operating voltage 100 - 240 V AC / 50 - 60Hz. Connection using the power cable supplied.
2
FUSE
Fuse holder for 5 x 20mm micro fuses. IMPORTANT: Replace the fuse only with a fuse of the same type and value. In the event of repeated
fuse failure, please contact an authorised service centre.
3
DMX IN
Male 3-pin and 5-pin XLR sockets for connection to a DMX control device (e.g. DMX console).
4 DMX OUT
Female 3-pin or 5-pin XLR sockets for sending the DMX control signal.
5
NET
RJ45 network connections for connecting to an Art-Net or sACN network and for connecting further Art-Net or sACN-capable devices to the
network. Use CAT-5e or better cables to set up the network.
6
NET STATUS LEDS
Yellow status LED lights up = network connection.
Green status LED flashes = control signal is present.
7
W-DMX™ ANTENNA
8 OLED DISPLAY
The OLED display shows the currently activated mode (main display), the menu items in the selection menu and the numerical value or
operating mode in certain menu items. If there is no input for approx. one minute, the display automatically returns to the main display. If no
control signal is present at the DMX input, the characters flash in the display (DMX and slave operation).
9
CONTROL BUTTONS
MENU - Pressing the MENU button will take you to the selection menu. Press again to return to the main display.
UP  and DOWN  - For selecting the individual menu items in the selection menu (DMX address, mode, etc.) and sub-menus, and
changing the value of a menu item, e.g. the DMX address.
ENTER – In the selection menu, press ENTER to access the menu level in which values can be changed. Confirm value changes by pressing ENTER.
3 4
8
3 4
2
9
1
5