Cameo EVOS S3 Bedienungsanleitung Seite 13

This will take you to the sub-menu for setting the following sub-menu items (selection with UP  and DOWN , confirm with ENTER,
change value/status with UP  and DOWN , confirm with ENTER):
Settings
Wireless Setting = W-DMX settings
(wireless DMX)
Display Reverse = Flip display
Display = Display lighting
DMX Fail = Operating status
with DMX signal
fault
Dimmer Curve = Dimmer curve
Pan reverse = Pan direction
Tilt Reverse = Tilt direction
Feedback = Position correction
Fan Setting = Adjusts fan speed
LED Frequency = LED PWM
frequency
Mov Blackout = Automatic black-
out during head
movement
W-DMX On/Off On = W-DMX enabled
Off = W-DMX disabled
Operating Mode Receive = W-DMX module as receiver
Transmit = W-DMX module as transmitter
Transmitting Mode G3 = G3 transmission standard
G4S = G4S transmission standard
Link Link = pair with W-DMX devices. W-DMX must be activated on
all devices and the pairing must be picked up by a transmitter
(Receive Reset).
Unlink = unpair all devices
Receive Reset No = do not retain transmitter pairing
Yes = retain transmitter pairing
On Rotate display by 180° (e.g. for overhead installation)
Off no display rotation
On permanent on
Off Deactivation after approximately 1 minute of inactivity
Hold last command is retained
Blackout activates blackout
Linear Light intensity increases linearly with DMX value
Exponential Light intensity can be finely adjusted at lower DMX values and
broadly adjusted at higher DMX values.
Logarithmic Light intensity can be broadly adjusted at lower DMX values and
finely adjusted at higher DMX values.
S-Curve Light intensity can be finely adjusted at lower and higher DMX
values and broadly adjusted at medium DMX values
On Reverses pan direction
Off does not reverse pan direction
On Reverses tilt direction
Off does not reverse tilt direction
On automatic position correction is enabled
Off automatic position correction is disabled
Regular Automatic fan speed control
Silent Extra quiet fan with reduced brightness
800Hz / 1200Hz / Configuration of LED PWM frequency
2000Hz / 3600Hz
/ 25kHz
On Blackout during head movement
Off no blackout during head movement
13