Cameo EVOS S3 Bedienungsanleitung Seite 9

STATIC MODE (Static)
The Static mode allows the Dimmer, Strobe, Colour wheel and Gobo wheel etc. to be adjusted directly on the device with values between
000 to 255, similar to a DMX control unit. In this way, an individual scene can be created without an additional DMX controller. Select static
mode as per the procedure previously described in SETTING OPERATION MODE and confirm with ENTER. Now use the control buttons UP 
and DOWN  to select the menu item you want to edit (see table below, observe arrow) and confirm with ENTER. The display now shows
a three-digit numeric field and allowing you to configure the desired value from 000 to 255. Confirm each entry by pressing ENTER. Press
MODE three times to return to the main display (Static Mode).
------------ Stand Alone ------------
Auto Programme
Static

Static
Pan 000
Pan fine 000
Tilt 000
Tilt fine 000
Dimmer 000
Dimmer Fine 000
Strobe 000
006
011
034
057
080
103
128
251
Cyan 000
Cyan Fine 000
Magenta 000
Magenta Fine 000
Yellow 000
Yellow Fine 000
CTO 000
CTO Fine 000
--------------- Static ---------------
Pan

Pan Fine
-
Pan Tilt Marco
Pan Tilt Speed
– 255 0% to 100%
– 255 0% to 100%
– 255 0% to 100%
– 255 0% to 100%
– 255 0% to 100%
– 255 0% to 100%
– 005 Strobe open
– 010 Strobe closed
– 033 Pulse random, slow -> fast
– 056 Ramp up random, slow -> fast
– 079 Ramp down random, slow -> fast
– 102 Random Strobe Effect, slow -> fast
– 127 Strobe Break Effect, 5s.....1s (Short burst with break)
– 250 Strobe slow -> fast <1Hz - 13Hz
– 255 Strobe open
– 255 0% to 100%
– 255 0% to 100%
– 255 0% to 100%
– 255 0% to 100%
– 255 0% to 100%
– 255 0% to 100%
– 255 0% to 100%
– 255 0% to 100%
40°C
000
-
Mode
255
Static
9