Replacing A Fuse - Emak Rider Gebrauchsanweisung

32
EN
6.5.2 Changing and repairing tyres
Tyres are of the «Tubeless» type and therefore all puncture repairs will have to be car-
ried out by a tyre-repair expert in accordance with the methods for this kind of tyres.

6.5.3 Replacing a fuse

The machine is fitted with fuses (1) with different
capacities and functions. Specifically:
– 10 A fuse = protects the main and power cir-
cuits of the electronic board. When it blows,
the machine stops and the dashboard light
switches off.
– 25 A fuse = protects the battery charger circuit.
When it blows, the battery gradually runs out
and the machine will have problems starting.
The fuse capacity is indicated on the fuse.
IMPORTANT
and ampere rating, and never one of a different rating.
If you cannot find the cause of the protection device's activation, consult a Licensed
Service Centre.
6.5.4 Changing belts
The motion from the engine to the rear axle and from the motor to the blade is
obtained by two "V" belts, whose duration largely depends on how the machine is
used.
Replacing belts is quite complicated because of dismantling and adjustments and
must only be carried out by a Licensed Service Centre.
NOTE
worn! ALWAYS USE MANUFACTURER'S GENUINE SPARE BELTS!
A blown fuse must always be replaced by one of the same type
Belts must always be replaced as soon as they are seen to be
MAINTENANCE
1