EMAK RIDER Gebrauchsanweisung Seite 64

24
EN
5.3.7 Summary of the main conditions whereby the safety devices
permit or stop work
The safety devices work in two ways:
– by preventing the engine from starting if all the safety requirements have not been
met;
– stopping the engine if even just one of the safety requirements is lacking.
a) To start the engine it will be necessary that:
– the transmission is in "neutral";
– the blade is not engaged;
– the operator is seated or the parking brake is engaged.
b) The engine stops when:
– the operator leaves his seat when the blades are engaged;
– the operator leaves his seat when the transmission is not in "neutral";
– the operator leaves his seat with the transmission in "neutral" but without engaging
the parking brake;
– the grass-catcher is lifted or the stone-guard is removed when the blades are
engaged;
– the parking brake is engaged without disengaging the blade.
The table below shows various operating conditions, highlighting why the safety
device shuts down the engine.
Operator Grass-catcher
A) WHEN STARTING (Key in «START» position)
Sitting Uninfluential
Sitting Uninfluential
Absent Uninfluential
B) WHEN CUTTING (Key in «ON» position)
Absent YES
Absent Uninfluential
Absent YES
Sitting
Sitting YES
5.3.8 Card protection device
The electronic card has a self-resetting protector which breaks the circuit if there is a
fault in the electrical system. It results in the stopping of the engine and is signalled by
the pilot lamp turning off.
The circuit automatically resets after a few seconds but the cause of the fault should
be ascertained and dealt with to avoid re-activating the protection device.
Blade
Disengaged
Engaged
Disengaged
Engaged
Disengaged
Disengaged
NO Engaged
Engaged
HOW TO USE THE MACHINE
Transmission
1....5 - F/R Engaged
«N» Engaged
«N» Disengaged
Uninfluential Engaged
1....5 - F/R Disengaged
«N» Disengaged
Uninfluential Disengaged
Uninfluential Engaged
Brake Engine
Does NOT start
Does NOT start
Does NOT start
Stops
Stops
Stops
Stops
Stops