Checks And Adjustments - Emak Rider Gebrauchsanweisung

30
EN
6.3.2 Rear axle
These are permanently lubricated with grease that does not need changing.
6.3.3 Battery
To ensure long life to the battery it is essential to
keep it carefully maintained.
The machine battery must always be charged:
– before using the machine for the first time after
purchase;
– before leaving the machine for a prolonged
period of disuse;
– before starting up the machine after a pro-
longed period of disuse.
– Carefully read and comply with the procedure
for recharging described in the booklet coming
with the battery. If the procedure is not fol-
lowed or the battery is not charged, irreparable damage could be caused to the ele-
ments inside the battery.
– A flat battery must be recharged as soon as possible.
IMPORTANT
voltage. Other recharging systems can irreversibly damage the battery.
The machine has a connector (1) for recharging, to be connected to the corresponding
connector of the special "CB01" maintenance battery-charger supplied (
or available on request (chapter 8).
IMPORTANT
maintenance battery-charger. For its use:
– follow the instructions given in the relative instruction booklet,
– follow the instructions given in the battery booklet.

6.4 CHECKS AND ADJUSTMENTS

6.4.1 Cutting deck adjustment
The cutting deck should be properly adjusted to obtain a good cut. Height adjust-
ments to the cutting deck are made through three linkages.
Such adjustments are to be made on a flat sur-
face after having ensured that the tyre pressures
are correct.
NOTE
from cutting, the front part should always be 2 -
4 mm lower than the rear.
Recharging must be done using a battery charger at constant
This connector must only be used for connection to the "CB01"
For achieving good results
1
2 1
MAINTENANCE
if included)