Dismantling And Replacement; Changing Wheels - Emak Rider Gebrauchsanweisung

MAINTENANCE
To adjust the cutting deck so that it is parallel
with the ground:
– put one 26 mm block (1) under the edge of the
deck and one 32 mm block (2) under the rear
edge, then put the lifting lever into the notch at
position «1»;
– loosen the nuts (3 - 5 - 7) and the locknuts (4 -
6 - 8) so that the deck is resting firmly on the
blocks;
– turn the nut (3) until the right-hand rear part of
the deck starts to rise, and then tighten the rel-
ative locknut (4);
– screw down the nut (5) on the rod until the
right-hand front part of the deck begins to rise,
and then tighten the relative locknut (6);
– screw the nut (7) on the front left support until
the deck in that area begins to rise, and then
tighten the nut (8).
If you are unable to get the cutting deck parallel,
consult a Licensed Service Centre.

6.5 DISMANTLING AND REPLACEMENT

6.5.1 Changing wheels

Stop the machine on a flat surface and put
blocks under a load-bearing part of the frame on
the side that the wheel is to be changed.
The wheels are held by a snap ring (1) which can
be taken off with a screwdriver.
The rear wheels are directly coupled to the axle
shafts and fastened by a key that forms part of
the wheel's hub.
Before re-fitting a wheel, smear some grease on the axle and carefully re-fit the snap
ring and washer (2).
NOTE
are of the same diameter, and check that cutting deck is horizontal to prevent an
uneven cut.
Should you substitute one or both rear wheels, ensure that they
EN
3
4
5 6
7
8
2 1
31