EMAK RIDER Gebrauchsanweisung Seite 59

HOW TO USE THE MACHINE
( for hydrostatic drive models) into neutral («N»);
– disengage the blade;
– on slopes, engage the parking brake:
Afterwards:
– put the accelerator lever to «CHOKE», as shown on the label, if the engine is cold. If
the engine is already warm, put the lever between «SLOW» and «FAST»;
– put in the key and turn to «ON» to make electrical contact, then turn to «START» to
start the engine. Release once the engine has started.
When the engine is running, put the accelerator into the «SLOW» position.
NOTE
starter motor for a long time as this can run down the battery or flood the engine.
Turn the key to the «OFF» position, wait for a few seconds and then repeat the oper-
ation. If the malfunction continues, refer to chapter «7» of this manual and to the
engine booklet.
IMPORTANT
from starting if safety requirements have not been met (see page 24).
The pilot lamp will begin flashing if the key is held in the «START» position when the
safety devices have been activated.
5.2.2 Moving without mowing
WARNING!
!
It has to be used (as indicated by the highway code) in private areas closed to
traffic.
NOTE
the cutting deck put at its highest position (position «7»).
Mechanical drive models:
Put the accelerator control between the «SLOW» and «FAST» positions, and the
gear change lever in the 1st speed position.
Keep the pedal pressed down and disengage the parking brake. Slowly release the
pedal which will turn from «brake» to «clutch», thus operating the rear wheels.
Should you have difficulties in starting do not continue to use the
Always bear in mind that the safety devices prevent the engine
The machine has not been approved for use on public roads.
When moving the machine, the blade must be disengaged and
19
EN