Maintenance; Safety Recommendations; Access To Mechanical Parts - Emak Rider Gebrauchsanweisung

MAINTENANCE

6. MAINTENANCE

6.1 SAFETY RECOMMENDATIONS

WARNING!
!
ignition key and read the relevant instructions. Wear adequate clothing and
work gloves whenever your hands are at risk.
WARNING!
!
or worn-out parts must always be replaced and not repaired. Only use original
spare parts: Parts that are not of the same quality can damage the equipment
and affect your safety and that of others.
IMPORTANT
unauthorised places!

6.2 ACCESS TO MECHANICAL PARTS

Lift the engine cover (1) to access the engine and
mechanical parts below it.
To do so:
– put the machine on level ground, bring the cutting
deck into the highest position and put blocks (2)
of around 65 - 70 mm beneath the edge to hold
up the deck during the following stages.
Mechanical drive models:
– engage the parking brake;
Hydrostatic drive models:
– put the drive release lever into the
«ENGAGED» position (see chap. 4, n° 23), since it is necessary
for the parking brake to be disengaged to ensure that the speed
change lever has enough movement;
– remove the grass-catcher or stone-guard;
– unscrew the knob on the lever (3) and put the lever into neutral «N» (
cal drive models), or in «R» (
– open the access hatch (4) and unscrew the nut (5) with a 13 mm spanner;
– release the lever (6) so that the deck rests on the blocks and keep the lever moved
sideways so that it is not in any of the notches. Hold the base of the seat (7) and tip
the cover back.
Before cleaning or doing maintenance work, take out the
Never use the machine with worn or damaged parts. Faulty
Never dispose of used oil, fuel, batteries or other pollutants in
for hydrostatic drive models);
1 3
2
27
EN
4 6
5
for mechani-